CPCS Training (A77) - Telescopic Handler 360 Slew Course - Foundation/Novice

Pre-requisites: Candidates must have completed the CSCS Health, Safety and Environment test for Operatives within the past two years. 

Course Content 

• Complete all manufacturer pre-start and running checks and prepare the excavator for travel 
• Prepare and set the telehandler for each lift, fit the relevant attachment 
• Forks Travel up and down the slope, over rough terrain and pass through a chicane. Stop and restart on incline (Loaded) 
• Forks - High lift and retrieve load. Lorry loading and unloading. Stack 3 loads certicllay and destack 
• Forks - Lift load and place at ground level at an indicated point using full reach ( horizontal) of the telehandler
• Forks - Lift load and reverse in a straight line for at least 20m, passing through a restriction at the end of the run
• Suspended Loads - Lift and place load at the given point below ground level or behind a structure. Create stack at given location 
• Hoist Rope - Lift load from min to max radius in relation to load, lift load and revesese for 20M and pass through a restriction
• Hoist Rope - Place load onto the vehicle bed. Lift load at max raduis and slew through 200° and land load within 2M of machines max raduis 
• Hoist Rope - Lift and load simulatea concrete pouring exercise by travelling the load in a straight line ( MIN 6M ) and Land load at given place 
• Hoist Rope - position machine so that stablisher footprint is 2M from base of tower and lift loa ( 75% raduis ) slew 90° and place on tower 
• Remove the hook / Hoist ope and return the machine ready for fork use. Park the amchine and carry out shut-down and securing procedures.

Certification: Upon successful completion of the course, candidates will receive a CPCS Trained Operator ' Red' card which is valid for two years.